Brandt, Robert
3 results
Now showing 1 - 3 of 3
- Some of the metrics are blocked by yourconsent settings
Publication Access status: Open Access , Influence of residual stresses on the crack initiation and short crack propagation in a martensitic spring steelThe crack initiation and short crack propagation in a martensitic spring steel were investigated by means of in-situ fatigue testing. Shot peened samples as well as untreated samples were exposed to uniaxial alternating stress to analyze the impact of compressive residual stresses. The early fatigue damage started in both sample conditions with the formation of slip bands, which subsequently served as crack initiation sites. Most of the slip bands and, correspondingly, most of the short fatigue cracks initiated at or close to prior austenite grain boundaries. The observed crack density of the emerging network of short cracks increased with the number of cycles and with increasing applied stress amplitudes. Furthermore, the prior austenite grain boundaries acted as obstacles to short crack propagation in both sample conditions. Compressive residual stresses enhanced the fatigue strength, and it is assumed that this beneficial effect was due to a delayed transition from short crack propagation to long crack propagation and a shift of the crack initiation site from the sample surface to the sample interior.Source Type:Article2 18 - Some of the metrics are blocked by yourconsent settings
Publication Access status: Open Access , On the low temperature creep controlling mechanism in a high strength spring steelDespite of the well-known fact that high strength steels are exhibiting low temperature creep deformation, its rate controlling mechanism is yet to be understood. The strain hardening theory and the exhaustion creep model were proposed almost seven decades ago to unravel the low temperature creep mechanism in a single phase homogeneous isotropic material. However, their applicability to low temperature creep deformation in a technical material like a modern high strength steel is still a matter of investigation owing to their nature of multi-phase, in-homogeneous, and an-isotropic behavior. The authors have grabbed this chance to experimentally validate the exhaustion creep model based on low temperature creep tests of the SAE 9254 spring steel.Source Type:Article297 173 - Some of the metrics are blocked by yourconsent settings
Publication Access status: Open Access , The impact of additive manufacturing on the mechanical properties of a stainless precipitation hardening steelA stainless precipitation hardening steel has been qualified for powder bed fusion of metals using a laser beam. The mechanical and microstructural properties of additively manufactured samples have been thoroughly investigated and compared to samples of the very same material made by means of ingot casting. Additive manufacturing is feasible and can deliver superior mechanical properties. Additionally, the surface quality will be improved by means of wet abrasive jet machining, and its impact on the residual stresses has been shown.Source Type:Article3 14
