Citation Link: https://doi.org/10.3390/polym15071660
On the Pin-Bearing Strength of Additively Manufactured Polymer Parts
Publication Type
Article
Subjects
Materials science
Digital image correlation
Composite material
Ultimate tensile strength
Stiffness
Fastener
Bearing (navigation)
Scanning electron microscope
Fused deposition modeling
Stress (linguistics)
Failure mode and effects analysis
3D printing
Computer science
Date Issued
2023
Abstract
Due to the wide scope of applications of additive manufacturing (AM) in making final products, the mechanical strength of AM parts has become very important. Therefore, different tests are being developed to determine the structural integrity of three-dimensional printed components. In this respect, the pin-bearing test is designed to evaluate the response of a fastener, plate, and hole to stress. In this study, two different polymer materials were used to fabricate the samples utilizing the fused deposition modeling technique. Since the specimen width and hole diameter have effects on the pin-bearing strength and structural integrity of the parts, we prepared the specimens with four hole diameters to determine the influence of this ratio. A series of tensile tests were performed, and the stiffness and pin-bearing strength of additively manufactured specimens were determined. The preferred bearing failure mode was observed in several tested specimens. Subsequently, a scanning electron microscope investigation was conducted on the damaged area of the examined specimens to obtain insights into the damage mechanisms and failure behavior of the aforementioned specimens. We used digital image correlation technique to determine the strain field of dumbbell-shaped test coupons. The results of this research can be utilized for new designs of AM parts with a higher mechanical strength.
Owning collection